MelPump › Compatibility › Airwell › katie test updated 2

Airwell katie test updated 2

Select an integration method below to see supported data points and features.

Monitored data points

Parameters available in the MelPump dashboard and reports. The "Control" column shows if you can also change the value from the app.

Parameter	Description	Monitor	Control
COP	Efficiency ratio - heat output divided by electricity input	check_circle	remove
Compressor Frequency	Speed of the compressor in Hz, higher values mean more heating or cooling power	check_circle	remove
Delta Temp	Difference between the water leaving and returning to the heat pump, used to show how much heat is being transferred	check_circle	remove
Input Power	Estimated electrical power being consumed	check_circle	remove
Output Power	Estimated heat energy being produced	check_circle	remove
Has Error	Indicates if the system has an active error	check_circle	remove
Flow Rate	Amount of water flowing through the system in litres per minute	check_circle	remove
Flow Rate	Amount of water flowing through the system in litres per minute	check_circle	remove
Indoor Temp #1	Current air temperature in rooms served by heating zone #1	check_circle	remove
Outdoor Temp	Current outside air temperature measured near the heat pump	check_circle	remove
Prohibit Heating Hot Water	When enabled, prevents hot water heating	check_circle	tune

Automation and optimization modes that MelPump unlocks for this integration.

bolt Advanced Scheduler

bolt Push and Email Notifications

bolt Energy Estimation

Free 30-day trial. No credit card required.